WTB: Aftermarket Turbo Inlet Hose

[100_Percent_Juice]

what the title says^

[sperry]

Wasn't there already a thread about this?

I think I've got a samco inlet hose in a box in my garage somewhere... I'm not sure about the condition. Let me find it and you can make me an offer?

[100_Percent_Juice]

no there wasnt, I mentioned it in a thread. I figured that I would follow forum protocol and post my WTB here. Please find your hose and then we can talk.

[sperry]

no there wasnt, I mentioned it in a thread. I figured that I would follow forum protocol and post my WTB here. Please find your hose and then we can talk.
:lol: "please find your hose"...

[sperry]

Okay, it took looking in 5 boxes, but I found it.

Pictures are attached. It's a blue samco inlet hose. One of the ports it blocked off because I was using a catch can that T'd into a single inlet, and since it's siliconed and hose clamped in there, I didn't pull the plug out out. If you want to run it with all the OEM hoses attached, I think it's just a matter of pulling out the plug.

Also the turbo side of things is a bit chewed up as the person that installed it on my GT30-10 had to stretch it to get it to fit and over-tightened the hose clamp. :( But that shouldn't keep it from working just fine.

I paid like $300 for it, I'll sell it for how about $75?

[100_Percent_Juice]

Looks good to me. Loren should be PMing you tomorrow. How hard would you say it is to install? time wise?

[sperry]

Looks good to me. Loren should be PMing you tomorrow. How hard would you say it is to install? time wise?
Taking out the old one and putting in the new one w/o removing the intake manifold is a PITA... I think it took MattR and I like 90 minutes at least when we did it down at ESX a while back.

[imprezif]

i just pm'd you about when would be a good time to get that thanks for taking the time to find it