Quote:
Originally Posted by Dean
We pulled the motor this morning the ABS controller and some of the hard lines over as well.
|
Thank for the help pulling the motor today dean. So it does look like I just need a new bellhousing. I was able to make a bit more progress tonight but ran into a small problem. The wheels that are on the car have wheel locks and i do not have the key. I already wasted two of my good sockets so i decided to call it quits.
here is a picture of the motor after we pulled it. Everything on the motor looked ok.
Also here is a picture of the messed up bellhousing and the input shaft that looks like it is bent from the picture but its just the little thing around it that is bent.
I finally was able to take out the ecu and harness after taking some last precautions to make sure everything was labeled properly.
and this last picture shows where i drilled out the spot welds that help the front light fixtures to the body that way I can do the 05 front end swap.
Tommorow night after work I am going to try to take out the tranny, axles, front and rear suspension, brakes, hub assembly, and rear diff. I really would like to have eveything stripped by tuesday night so i can take this thing to the scrap metal place.