Quote:
Originally Posted by Dean
We pulled the motor this morning and the input shaft appears to spin straight and true, so a new bell/front diff housing should be all he needs.
Sam's made a lot of progress with all the big stuff, but he still has a ways to go with the little stuff. Since he is moving the harness over, I think he may have to move the ABS controller and some of the hard lines over as well.
|
You will need all 6 of the hard lines from the front of the car, make sure to take the rear proportioning valve off of the Pass. side front strut tower too. I just swapped all of mine because I am using the 05+ abs pump and it was a huge PITA to swap with the engine in.