So I have wheels, need to order tires, new valve stems should be here soon (couldn't rock the blue ones the wheels came with), and need to track down front and rear camber plates, and make some fender rolling happen. Also need to do a front stud swap.
Need to open up the fenders a bit. At my current alignment (~2*f, 1.5r I think?) the wheels are approx. 1/2" outside the fenders. That's really not a whole lot considering the front are untouched, and the rears are very minorly rolled.
Not sure if this pic will work, was too lazy to upload to Photobucket:
So, where to get some extended studs from? Need 8mm spacers as well, or 10mm...