Subaru Enthusiasts Car Club of the Sierras - View Single Post

A1337STI · 2012-03-05, 05:27 PM

Are GC knuckles compatible? you could borrow one of my spares for a little while to get you by.

i know the strut attatchment is the same.

i know the brake calipers would bolt up,

not sure about A-arm attachment and the half shaft splines though ..

all my spares are pick n pull finds but if you just need something to get you buy for a few weeks you can borrow one no problem.

i'll pm you my number in case you need to go this route.

new wheel bearing into your hub is the proper solution (unless your hub is damaged)

nothing wrong with driving around on a pick n pull hub assembly though ...

2012-03-05, 05:27 PM	#3
A1337STI EJ205 Join Date: Jan 2006 Location: Reno, NV Posts: 1,840 Car: Impreza and an Impreza Class: AS / CRS PerfStock "pedal on the right"	Are GC knuckles compatible? you could borrow one of my spares for a little while to get you by. i know the strut attatchment is the same. i know the brake calipers would bolt up, not sure about A-arm attachment and the half shaft splines though .. all my spares are pick n pull finds but if you just need something to get you buy for a few weeks you can borrow one no problem. i'll pm you my number in case you need to go this route. new wheel bearing into your hub is the proper solution (unless your hub is damaged) nothing wrong with driving around on a pick n pull hub assembly though ... __________________ Fighting uphill battles, one bullet at a time!