Quote:
|
Originally Posted by sperry
If the gauge is just blinking it means the display is connected to the control box, but the sender is not giving it data. My guess is either the sender has failed, or become disconnected from the control box. Check the connection between the sender and the control unit... if it's fine, chances are you need a new sender.
|
The connection looks OK, but nothing happens between the control unit and the guage. For instance the peak does not read nor can I toggle through peak settings on that guage. The guage has power and goes through the start and end sequence in the normal fashion.
If it is the sender (I am assuming this is the wire from the control unit to the guage), where can you get replacements?