[Kevin M]

I think the first drawing did would work fine, but it doesn't isolate teh left and rights sides. Any single component failure could disable my lights entirely, so wehn you posted yours I tossed that one and built the one you drew.

Unfortunately, you guessed it... the high beams lock themselves on. I have to kill the lights to get them back to lowbeam only.

The new schematic should work fine, but I was thinking that if resistance of the high beam shield solenoid is high enough, they may not ground out when I hit flash-to-pass. Other than that they should be perfect.

Thanks for your help dude. I probably would have eventually figured this out (hopefully without killing a ballast) but you definitely sped up the process for me.