So I bought one of these, because I need one instead of the burned-out sensor I usually use to plug the MAF sensor hole. I feel a little dumb writing that diatribe above. Grimm did a nice job with the snout length and split the difference between all the intake combos I checked. It is not flush on a 65mm intake, it is very nicely flush on 70mm & 83mm intakes, and it only protrudes like 2mm on 73mm & 86mm intakes. The o-ring does extend past the machined flange on some of the intakes, but it is so tight I think it would seal fine. The o-ring is very very tight in the bore, so much so that you need the screws to pull the plate down into the intake. Not sure I like that but it is better than too loose. I may post some pics sometime.
Shipping was fast - 2 days after I ordered it it was tossed onto my porch by the friendly postal worker who doesn't like all the packages I ship.
|